What does it mean when your boiler says ignition fault?
What does it mean when your boiler says ignition fault?
What does ignition lockout mean on a boiler? Some of the problems mentioned above could cause your boiler to go into ignition lockdown. This means that the boiler has turned itself off because of an issue, such as low water pressure, no gas supply or a lack of electricity.
How do I reset my Potterton Promax he boiler?
- Reset. bar.
- Off position. The boiler will not operate.
- Central heating. and hot water. Both heating and. hot water will operate.
- Hot water. Hot water will operate.
- Reset. Hold for approximately. 5 seconds and release.
Why is my Potterton boiler not igniting?
Loose or damaged wiring – the PCB isn’t receiving the signal it needs. A faulty air pressure switch – the switch is sending the wrong signals to the boiler. A broken PCB – it’s not giving or receiving the correct signals from the PCB and fan.
How do I fix my ignition lockout?
Most modern gas furnaces can be reset by turning off the power, waiting around 20 seconds, then switching the power back on. Other furnace models may exit lockout after 1-2 hours and attempt to power on again. If your furnace has a pilot light, you may need to relight it following the manufacturer’s instructions.
Why does my Potterton boiler need resetting?
Common underlying causes include: A pump fault. A faulty electric part. A blocked plate heat exchanger. An old or worn out component.
What causes ignition lockout fault?
Defective flame sensors are one of the most common causes of lockouts. When your furnace begins to start, the sensor checks for the presence of fire. If the sensor is faulty or dirty, it won’t be able to detect the flame and the controller will stop the ignition sequence.
What does a green flashing light mean on a Potterton boiler?
When there is a call for heat the Status LED will flash Green and after several seconds the burner will light automatically. The Status LED will show continuous Green whilst water is being heated. If the Status LED is showing continuous or flashing Red the boiler will need resetting.