How do I fix my Magic Bullet not working?

There may be food stuck between the blades Turn off and unplug your Magic Bullet for safety. Then, remove and thoroughly clean out any food found between the blades that may be stopping the blades from functioning properly.

Why is my Magic Bullet not blending?

In order for the NutriBullet to blend, there are special white activators on the top of the power base which begins the blending process. If the blades fail to turn when the cup is in the powerbase, the activators could be stuck. Follow these instructions to replace the activators.

How do I fix my blender blade not spinning?

Step 1: Remove the blender base and locate the fuse in the wire from the multispeed switch to the motor. Step 2: Disconnect the wire and use a continuity tester or multitester to check the fuse. If the circuit is open, the fuse is blown. Step 3: Replace the faulty in-line fuse with one of identical rating.

How do you unscrew a Magic Bullet lid?

1. Unplug the unit.
2. Turn the unit upside down (with the cup still attached)
3. As the entire unit is upside down, tap the top of the cup gently on the ground a few times.
4. Twist the cup counter-clockwise and it should pop right out.

How do you clean the inside of a Magic Bullet?

An easy and efficient way to clean stuck-on ingredients is to fill your cup with warm water and dish soap, screw on the extractor blade, and run your nutribullet for 20-30 seconds. This will loosen stuck-on ingredients and with a light scrub and rinse, you’ll be finished cleaning your cup and blade.

How do you reset a Magic Bullet?

If the motor stops working, unplug the Power Base and let it cool for a few hours before attempting to use it again. Your Magic Bullet® has an internal thermal breaker that shuts the unit off when it overheats. Letting the thermal breaker cool down should allow it to reset.

Why does my blender get stuck?

The issue of cavitation—when your blender gets stuck because of a big air bubble—is one that can literally stop you in your tracks. To prevent lock-up, be sure to keep a good balance between the ice (or any frozen food) and the liquid that you’re combining. You can also use the “Pulse” feature to dislodge it.

Can you take apart a Magic Bullet blade?

To remove the blade gear, turn the Magic Bullet on its side and use a flat tip screw driver on the bottom end, and the pliers on the base gear. Turn the blade gear in clock wise direction to remove it off the shaft. The blade gear has a left-hand thread, which is opposite to the normal screw thread.

Can you run water through a Magic Bullet?

This high heat can melt the plastic Magic Bullet cups. Never submerge the electrical base of the Magic Bullet in water. This can damage the appliance.

Is the magic bullet worth it?

Even though the Magic Bullet is an affordable personal blender, it’s a workhorse. One editor on our team has owned it for 15 years and plans to continue using it until it literally won’t work anymore. She primarily uses it for smoothies, but says it makes excellent sauces and marinades, too.