How do you unstick ps3 controller buttons?

A little bit of rubbing alcohol on a Q-tip never hurt. ^This works well. Or if you don’t want to dismantle the controller if the button is only slightly sticking you can get an old toothbrush dampen the bristles (not so much that liquid runs off them) and brush around the button cavity well.

Why do PS3 controllers get sticky?

When the controller is in normal use, you’re always pushing on top of the thumb sticks so all that grime stays inside, but given a chance to sit, all this excess material starts to ooze out of the rubber. Then, holding the stick to the side and using a cloth to wipe it down did the trick.

Why does my PS3 controller keep turning off?

To reduce battery consumption, controllers will automatically turn off if they are idle for a certain duration. Select [Power Save Settings] > [Turn Off Wireless Controllers Automatically], and then set the duration. Press the PS button to turn on the controller.

Why is my R2 button sticking?

Could be a number of issues: the plunger on the inside of the button could be cracked, the button switch could be loose, or there could be dirt or damage to the button switch.

How do you remove the analog stick from a PS3 controller?

Lift up the lower edge of the back cover and push it slightly forward until it clears the bottom trigger buttons. Use light pressure and move slowly to keep from accidentally popping off one of the trigger buttons. After the back cover has cleared the trigger buttons, remove it from the controller.

What’s the best way to fix a PS3 controller?

You may need to pry open the controller with a flat head screwdriver. Open it from the bottom and carefully tilt it towards the top shoulder buttons. Be very careful that you don’t accidentally dislodge the R2 or L2 trigger buttons while removing the back.

What to do if your PS3 has water damage?

Fix Water Damage Power off the controller immediately. Remove screws from the back of the controller. Remove the back. Disconnect the battery. Place the controller under a lamp, fan, or window. Wait at least 24 hours. Reconnect the battery. Replace the controller back. Replace the screws on the controller back. Test the controller.

Where is the input Board on a PS3 controller?

Attached to the motherboard is the button input board. Push the vibration motors out of their slots on the input board. Lift the input board off the motherboard. Repeat the above steps for the “As is” DualShock 3. Remove the motherboard from the “As is” DualShock 3. Connect the old input board to it.