Why is my Weiser lock not working?

Press and hold the program button while reinserting the battery pack. Hold the program button for 30 seconds until the status LED flashes red. Press the program button again. The lock has been reset when the LED flashes green.

How do I reset my Weiser keypad?

Weiser Lock reset:

1. Remove the battery cover using the Allen key.
2. Remove the battery pack.
3. Press and hold the program button while reinserting the battery pack.
4. Hold the program button for 30 seconds until the status LED flashes red.
5. Press the program button again.

Why does my Weiser lock keep beeping?

The lock should beep twice when it unlocks and once when it locks. It will also beep if there is a warning such as a low battery or a jammed bolt. To turn the beeping sound off: Reinstall the battery cover.

How do I reprogram my Weiser Smart lock?

Press and HOLD Program button until keypad flashes green (about 5 seconds). Enter new mastercode. Press Lock button once. Re-enter mastercode.

How do you reprogram a SmartCode door lock?

How to restore default settings on my SmartCode lever? Perform a factory reset

1. Remove battery pack.
2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red.
3. Press the Program button once more.

How do you unlock a Weiser keypad lock?

keyless entry- lock or unlock at the touch of a button.

1. The door is now locked. To unlock the door, touch the.
2. SecureScreen™ Touch the numbers in any order. to display the full touchscreen.
3. Enter your code. Enter the access code.
4. Wrong code. Enter the access code.
5. The door is now unlocked. Tap the lock button to start over.

Why does my lock keep beeping?

If your Electronic Door Lock is beeping and the buttons are flashing red, this means that there’s been some kind of error or the batteries are low. If the batteries have already been changed and you still see a red flashing light when you try to use the lock, there could be an error with the lock.

Why is my Weiser lock flashing red?

The battery is too low to lock the door. This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set. The latch is installed upside down.

How do you lock a Weiser battery pack?

Press and hold the “LOCK” button on the exterior keypad, while fully inserting the battery pack into the interior assembly (the tab on the pack must face out – see illustration). Hold down lock button until you hear 2 beeps (about 20 seconds).

Why do you need a Weiser Powerbolt lock?

Change your code regularly to avoid unwanted entry. A door is only as safe as its lock, and a lock is only useful if it’s functioning properly. The Weiser Powerbolt is a touchpad-enabled deadbolt system that, if operating correctly, can keep the bad guys out and your home secure.

What’s the factory override code on Weiser Powerbolt?

Use your factory override codes. Your Weiser Powerbolt comes with two pre-set factory codes. If you have forgotten your code, you can use one of these two included codes to override the lock. Paul Betters is a freelance writer who is currently working out of Providence, R.I.